Mixing Ratio for 1 Bag of Cement in Concrete By Maawa World


Comments

Post a Comment

Popular posts from this blog

ATTERBERG LIMITS

ATTERBERG LIMITS The Atterberg limits are water contents which define the limits of various stages of consistency for fine-grained soils. The liquid limit (LL) and the plastic limit (PL) define the upper and lower limits, respectively, of the plastic range of a soil; the numerical difference between these two limits expresses the plasticity of a soil and is termed the plasticity index (PI). Liquid Limit The liquid limit of a soil is the water content, expressed as a percentage of the weight of oven-dried soil at which two halves of a soil pat separated by a groove of standard dimensions will close at the bottom of the groove along a distance of 1/2 in. under the impact of 25 blows in a standard liquid limit device. Plastic Limit The plastic limit of a soil is the water content, expressed as a percentage of the weight of oven dried soil at which the soil just begins to crumble into short pieces when rolled into a thread 1/8 in.  in diameter. P...
Read more

FIBRE-REINFORCED CONCRETE (FRC)

FIBRE-REINFORCED CONCRETE (FRC) Plain concrete possesses deficiencies like low tensile strength, limited ductility and low resistance to cracking. The cracks develop even before loading. After loading micro cracks widen and propagate, exposing concrete to atmospheric actions. If closely spaced and uniformly dispered fibres are provided while mixing concrete, cracks are arrested and static and dynamic properties are improved. Fibre reinforced concrete can be defined as a composite material of concrete or mortar with discontinuous and uniformly distributed fibres. Commonly used fibres are of steel, nylon, asbestos, coir, glass, carbon and polypropylene. The length to lateral dimension of fibres range from 30 to 150. The diameter of fibres vary from 0.25 to 0.75 mm Fibre reinforced concrete is having better tensile strength, ductility and resistance to cracking. Uses of FRC 1. For wearing coat of air fields, roads and refractory linings. 2. For manufacturing precast products lik...
Read more

Properties of Bricks

Properties of Bricks The following are the required properties of good bricks: (i) Colour: Colour should be uniform and bright. (ii) Shape: Bricks should have plane faces. They should have sharp and true right angled corners. (iii) Size: Bricks should be of standard sizes as prescribed by codes. (iv) Texture: They should possess fine, dense and uniform texture. They should not possess fissures, cavities, loose grit and unburnt lime. (v) Soundness: When struck with hammer or with another brick, it should produce metallic sound. (vi) Hardness: Finger scratching should not produce any impression on the brick. (vii) Strength: Crushing strength of brick should not be less than 3.5 N/mm2. A field test for strength is that when dropped from a height of 0.9 m to 1.0 mm on a hard ground, the brick should not break into pieces. (viii) Water Absorption: After immercing the brick in water for 24 hours, water absorption should not be more than 20 per cent by weight. For class-I work...
Read more